Individual HPLC Components and Accessories
MilliporeSigma™ Supelco™ PlatePrep 96-well Vacuum Manifold
The PlatePrep vacuum manifold consists of a clear acrylic top allowing for easier inspection of flow rates during SPE 96-well plate processing. The polypropylene base offers excellent chemical resistance while a single remote vacuum gauge/bleed valve controls flow through all the wells.
MilliporeSigma™ Supelco™ Rheodyne™ Model 9725 Injector
Manual, Number of ports: 6, Number of positions: 2
MilliporeSigma™ Supelco™ Rheodyne™ Model 7000L Stream Switching Valve, Large Bore
Manual, Number of ports: 6 and Number of positions: 2
MilliporeSigma™ Supelco™ PHRED Photochemical Reactor
PHRED photochemical reactor can be used effectively to improve analyte detection in the presence of interfering matrix components, or when the analytes are present at low concentrations.
MilliporeSigma™ Supelco™ Hydrocarbon Kit acc. to DIN EN 14039/ISO 16703
Kit contains:
- mineral oil standard for calibration 8 mg/ml in heptane
- alkane standard solution
- heptane
- standard solution for the determination of the retention time
- Florisil™ tubes
Thermo Scientific™ Rheodyne™ 7010 Sample Injector
Ensure accurate and precise high-volume HPLC injections with the single-mode Thermo Scientific™ Rheodyne™ 7010 Sample Injector.
Thermo Scientific™ Dionex™ Ultra-Low Dead Volume Union
Thermo Scientific™ Ultra-Low Dead Volume Union is for nano electrospray ionization.
Cytiva Frac30 Model Fraction Collector
Used as a round fraction collector. Cytiva Frac30 Model Fraction Collector allows you to collect up to 30 fractions.
Synthware™ High Vacuum Valve Plug, PTFE Protected
Complete with control knob. Viton™ O-rings on PTEF shaft are protected with precision PTFE wipers.
Synthware™ PTFE Protected High Vacuum Valves
High vacuum valves are fully enclosed, and include teflon-covered O-rings for increased durability.
Synthware™ Metering High Vacuum Valve Plug
Designed to provide an excellent vacuum tight seal.
Synthware™ 180° High Vacuum Plug and Control Knob
Accessory for S560004 180° High Vacuum Valve
Synthware™ 180° High Vacuum Valve
With two 9 mm O.D. sidearms sealed to the barrel at a 180° angle to one another. Viton™ O-ring on PTFE shaft are protected with precision PTFE wipers. The plug has a machined-in integral PTFE tip O-ring to make the primary seal. This design provides for an excellent vacuum tight seal without exposing any material other than PTFE to chemicals.
Synthware™ Low Hold Up High Vacuum Valve
Side Arm OD: 9 mm
Synthware™ Check Valve
Gound seat for liquid seal.